提出采用电子冷却液NOVEC 7000为工质的电池液体冷却实验系统，开展实验研究。研究结果表明，该系统具有良好的电池冷却效果。实验结果表明，产热机理不同，不同倍率放电时，电池呈现出不同的温度变化特性。发现温度对电池性能有着双重影响：尽管采用热管理手段能够降低电池表面温度，提高电池安全性，但是相应的电池电化学性能严重下降。质量流量的增大能够有效地降低电池表面最大温度，但在热管理系统的设计中必须考虑质量流量增大造成的附加功率（如泵功率）的消耗。在持续充放电过程中，NOVEC 7000工质的沸腾将电池的表面最大温度稳定地维持在34~36℃之间。而以乙二醇溶液为工质时，温度则保持持续增大的趋势。基于微细通道内沸腾换热的电池热管理系统，可以在保证电池热安全性的同时，有效提高系统经济性。
A battery liquid cooling system which uses new electronic cooling fluid NOVEC 7000 as the working medium was proposed and some experimental investigation was carried out. The results showed that this system had excellent cooling effect. Temperature variation showed different regularities when the battery was discharged at different rates due to the different heat generation mechanisms. The effect of temperature on battery was bidirectional. Although the battery thermal management system effectively decreased the battery temperature and improved the thermal safety, the electrochemical performance declined as well. The maximum temperature of battery surface was effectively reduced with the increase in mass flow rate, but parasitic power resulting from the increase in mass flow rate, such as pump power consumption, should be considered. During cyclic charging/discharging, because of the boiling phenomenon, the maximum temperature of battery surface could be stably maintained between 34℃ and 36℃ when NOVEC 7000 was used as working medium.However, the temperature kept rising tendency while glycol was used as cooling medium. So, designing a battery thermal management system, based on flow boiling in mini/micro-channel, will effectively improve the thermal safety of batteries as well as the economy.
[1] Chambers A, Nakicenovic N. World energy outlook[EB/OL]. Paris:International Energy Agency.(2008)[2017-10-11]. http://www.iea.org.
[2] Chau K T, Wong Y S, Chan C C. An overview of energy sources for electric vehicles[J]. Energy Conversion and Management, 1999, 40(10):1021-1039.
[3] Panchal S, Dincer I, Agelin-Chaab M, et al. Experimental and theoretical investigation of temperature distributions in a prismatic lithium-ion battery[J]. International Journal of Thermal Sciences, 2016, 99:204-212.
[4] Ritchie A, Howard W. Recent developments and likely advances in lithium-ion batteries[J]. Journal of Power Sources, 2006, 162(2):809-812.
[5] Abada S, Marlair G, Lecocq A, et al. Safety focused modeling of lithium-ion batteries:a review[J]. Journal of Power Sources, 2016, 306:178-192.
[6] Kuper C, Hoh M, Houchin-Miller G, et al. Thermal management of hybrid vehicle battery systems[C]//24th International Battery, Hybrid and Fuel Cell Electric Vehicle Conference and Exhibition (EVS-24):Stavanger, Norway:2009:1-10.
[7] Giuliano M R, Prasad A K, Advani S G. Experimental study of an air-cooled thermal management system for high capacity lithium-titanate batteries[J]. Journal of Power Sources, 2012, 216:345-352.
[8] Wang T, Tseng K J, Zhao J, et al. Thermal investigation of lithium-ion battery module with different cell arrangement structures and forced air-cooling strategies[J]. Applied Energy, 2014, 134:229-238.
[9] Rao Z, Huo Y, Liu X, et al. Experimental investigation of battery thermal management system for electric vehicle based on paraffin/copper foam[J]. Journal of the Energy Institute, 2015, 88(3):241-246.
[10] Javani N, Dincer I, Naterer G F, et al. Modeling of passive thermal management for electric vehicle battery packs with PCM between cells[J]. Applied Thermal Engineering, 2014, 73(1):307-316.
[11] 饶中浩, 汪双凤, 洪思慧, 等. 电动汽车动力电池热管理实验与数值分析[J]. 工程热物理学报, 2013, 34(6):1157-1160.
[12] Zhao R, Gu J, Liu J. An experimental study of heat pipe thermal management system with wet cooling method for lithium-ion batteries[J]. Journal of Power Sources, 2015, 273:1089-1097.
[13] Rao Z, Huo Y, Liu X. Experimental study of an OHP-cooled thermal management system for electric vehicle power battery[J]. Experimental Thermal and Fluid Science, 2014, 57:20-26.
[14] Pesaran A A. Battery thermal management in EV and HEVs:issues and solutions[J]. Battery Man, 2001,43(5):34-49.
[15] Tong W, Somasundaram K, Birgersson E, et al. Numerical investigation of water cooling for a lithium-ion bipolar battery pack[J]. International Journal of Thermal Sciences, 2015, 94:259-269.
[16] Zhao J, Rao Z, Li Y. Thermal performance of mini-channel liquid cooled cylinder based battery thermal management for cylindrical lithium-ion power battery[J]. Energy Conversion and Management, 2015, 103:157-165.
[17] Hirano H, Tajima T, Hasegawa T, et al. Boiling liquid battery cooling for electric vehicle[C]//Transportation Electrification Asia-Pacific (ITEC Asia-Pacific), 2014 IEEE Conference and Expo. IEEE, 2014:1-4.
[18] Nelson P, Dees D, Amine K, et al. Modeling thermal management of lithium-ion PNGV batteries[J]. Journal of Power Sources, 2002, 110(2):349-356.
[19] Bernardi D, Pawlikowski E, Newman J. A general energy balance for battery systems[J]. Journal of the Electrochemical Society, 1985, 132(1):5-12.
[20] Gu W B, Wang C Y. Thermal-electrochemical modeling of battery systems[J]. Journal of The Electrochemical Society, 2000, 147(8):2910-2922.
[21] Doyle M, Fuller T F, Newman J. Modeling of galvanostatic charge and discharge of the lithium/polymer/insertion cell[J]. Journal of the Electrochemical Society, 1993, 140(6):1526-1533.
[22] Mohammadian S K, He Y L, Zhang Y. Internal cooling of a lithium-ion battery using electrolyte as coolant through microchannels embedded inside the electrodes[J]. Journal of Power Sources, 2015, 293:458-466.
