欢迎访问中国科学院大学学报,今天是

中国科学院大学学报 ›› 2018, Vol. 35 ›› Issue (2): 193-199.DOI: 10.7523/j.issn.2095-6134.2018.02.007

• 中国工程热物理学会2016年传热年会专栏 • 上一篇    下一篇

孔隙分布不均匀性对渗透率影响的MRTLBM法研究

马斌1, 史琳2, 黄超2, 许强辉2   

  1. 1. 兰州交通大学机电工程学院, 兰州 730070;
    2. 清华大学能源与动力工程系工程热物理研究所, 北京 100081
  • 收稿日期:2017-05-02 修回日期:2017-09-25 发布日期:2018-03-15
  • 通讯作者: 史琳
  • 基金资助:
    国家自然科学基金面上项目(51236004)和国家自然基金创新团队项目(51621062)资助

Study on heterogeneity of pore structure to permeability by MRT LBM

MA Bin1, SHI Lin2, HUANG Chao2, XU Qianghui2   

  1. 1. School of Mechanical Engineering, Lanzhou Jiaotong University, Lanzhou 730070, China;
    2. Insitute of Engineering Thermophysics, Department of Energy and Power Engineering, Tsinghua University, Beijing 100081, China
  • Received:2017-05-02 Revised:2017-09-25 Published:2018-03-15

摘要: 孔隙率与渗透率是多孔介质非常重要的属性参数,采用MRT LBM研究孔隙率损失与渗透率损失相关性以及同孔隙率异构孔隙对渗透率特性的影响。结果表明:当存在使孔隙率均匀变小的沉积、沉降或结焦等因素时,渗透率损失率是孔隙率损失率的2倍左右;同孔隙率异构多孔体中,渗透率有巨大差异;同孔隙率异构多孔体中最大孔喉最小孔喉比越大渗透率越小;同孔隙率多孔体中迂曲度越大渗透率越小。

关键词: 渗透率损失, MRT LBM, 同孔隙率异构多孔体, 最大孔喉最小孔喉比, 迂曲度

Abstract: Porosity and permeability are very important characters of a porous media.In this work, MRT LBM was used to study the pore structure influence on permeability and the porosity loss influence on permeability loss. Our simulation results are shown as follows. If there are some factors which cause even decreasing of porosity, such as that of depositing, sediment, and coking, the scope of permeability loss is larger than that of porosity loss. In same-porosity-different-structure (SPDS) porous media, there are extraordinary differences in permeability depending on their own pore structures.A larger ratio of max throat length to min throat length leads to a smaller permeability,and a larger tortuosity leads to a smaller permeability.

Key words: permeabilty loss, MRT LBM, SPDS, ratio of max throat length to min throat length, tortuosity

中图分类号: