压水堆燃料棒束新型定位格架的数值分析

doi:10.7523/j.issn.2095-6134.2018.02.008

中国科学院大学学报 ›› 2018, Vol. 35 ›› Issue (2): 200-208.DOI: 10.7523/j.issn.2095-6134.2018.02.008

• 中国工程热物理学会2016年传热年会专栏 • 上一篇下一篇

压水堆燃料棒束新型定位格架的数值分析

梁好玉, 武俊梅

西安交通大学机械结构强度与振动国家重点实验室, 西安 710049

收稿日期:2017-04-18 修回日期:2017-08-15 发布日期:2018-03-15
通讯作者: 武俊梅
基金资助:
国家自然科学基金（51336006）资助

Numerical analysis of a novel spacer grid in rod bundles of PWR

LIANG Haoyu, WU Junmei

State Key Laboratory for Strength and Vibration of Mechanical Structures, Xi'an Jiaotong University, Xi'an 710049, China

Received:2017-04-18 Revised:2017-08-15 Published:2018-03-15

摘要/Abstract

摘要： 定位格架是反应堆燃料组件中较为重要的部分，带搅混叶片的AFA-2G/3G定位格架具有良好的支撑燃料棒束和强化棒束通道换热的性能，但结构复杂，加工难度大。设计一种制造工艺相对简单的带有矩形涡旋发生器（longitudinal vortex generators，LVGs）的新型定位格架，研究当此种定位格架用于5×5的燃料棒束时的热工水力特性。主要采用标准k-ε湍流模型和增强型壁面函数处理方法，分析雷诺数和LVGs攻角对流体换热的影响。结果表明：由LVGs产生的二次流扩散到下游区域并对燃料棒的边界层产生扰动，增强换热；60°和45°攻角的矩形涡旋发生器（RLVGs）的换热效果几乎相同，但60°攻角RLVGs的阻力和压降较大。本研究对这种新型燃料组件的工程设计具有一定的参考价值。

关键词: 燃料组件, 定位格架, 涡旋发生器, CFD

Abstract: Spacer grid is an important part of fuel assembly in reactor. The AFA-2G/3G spacer with mixing vane supports rod bundles well and enhances the heat transfer, but it has a complex structure and difficult processing. A novel spacer grid with the rectangular longitudinal vortex generators (RLVGs) is designed to improve thermal-hydraulic characteristics of fuel assembly. Based on the standard k-ε model with the enhanced wall treatment, a three-dimensional numerical simulation of the novel spacer grid in the channel of PWR fuel rods is presented. The effects of Reynolds number and attack angle are investigated. Numerical results show that the second flow generated by LVGs spreads to the downstream region of spacer grid and improves the heat transfer. The spacer grids with RLVGs with attack angles of 60° and 45° result in almost equal heat transfer performances. However, the spacer grid with RLVGs with attack angle of 60° brings about more pressure drop in comparison with that of the 45° case. The present research on new fuel assembly has certain potential value for the engineering design.

Key words: fuel assembly, spacer grid, longitudinal vortex generator, CFD

中图分类号:

TL421+.1

梁好玉, 武俊梅. 压水堆燃料棒束新型定位格架的数值分析[J]. 中国科学院大学学报, 2018, 35(2): 200-208.

LIANG Haoyu, WU Junmei. Numerical analysis of a novel spacer grid in rod bundles of PWR[J]. , 2018, 35(2): 200-208.

参考文献

[1] Holloway M V, Beasley D E, Conner M E. Single-phase convective heat transfer in rod bundles[J]. Nuclear Engineering and Design, 2008,238(4):848-858.
[2] Han S Y, Seo J S, Park M S, et al. Measurements of the flow characteristics of the lateral flow in the 6×6 rod bundles with Tandem Arrangement Vanes[J]. Nuclear Engineering and Design, 2009,239(12):2728-2736.
[3] Nematollahi M R, Nazifi M. Enhancement of heat transfer in a typical pressurized water reactor by different mixing vanes on spacer grids[J]. Energy Conversion and Management, 2008,49(7):1981-1988.
[4] Shin B S, Chang S H. CHF experiment and CFD analysis in a 2×3 rod bundle with mixing vane[J]. Nuclear Engineering and Design, 2009,239(5):899-912.
[5] Tóth S, Aszódi A. CFD analysis of flow field in a triangular rod bundle[J]. Nuclear Engineering and Design, 2010,240(2):352-363.
[6] Zhu X, Morooka S, Oka Y. Numerical investigation of grid spacer effect on heat transfer of supercritical water flows in a tight rod bundle[J]. International Journal of Thermal Sciences, 2014, 76(2):245-257.
[7] Tseng Y S, Ferng Y M, Lin C H. Investigating flow and heat transfer characteristics in a fuel bundle with split-vane pair grids by CFD methodology[J]. Annals of Nuclear Energy, 2014, 64(64):93-99.
[8] Bieder U, Falk F, Fauchet G. LES analysis of the flow in a simplified PWR assembly with mixing grid[J]. Progress in Nuclear Energy, 2014, 75(1):15-24.
[9] Podila K, Rao Y F, Krause M, et al. A CFD simulation of 5×5 rod bundles with split-type spacers[J]. Progress in Nuclear Energy, 2014, 70(1):167-175.
[10] Johnson T R, Joubert P N. The influence of vortex generators on the drag and heat transfer from a circular cylinder normal to an airstream[J]. Journal of Heat Transfer, 1969,91(1):91-99.
[11] Ahmed H E, Mohammed H A, Yusoff M Z. An overview on heat transfer augmentation using vortex generators and nanofluids:approaches and applications[J]. Renewable and Sustainable Energy Reviews, 2012,16(8):5951-5993.
[12] Wu J M, Tao W Q. Investigation on laminar convection heat transfer in fin-and-tube heat exchanger in aligned arrangement with longitudinal vortex generator from the viewpoint of field synergy principle[J]. Applied Thermal Engineering, 2007,27(14/15):2609-2617.
[13] Gandhir A, Hassan Y. RANS modeling for flow in nuclear fuel bundle in pressurized water reactors (PWR)[J]. Nuclear Engineering and Design, 2011,241(11):4404-4408.
[14] Liu C C, Ferng Y M, Shih C K. CFD evaluation of turbulence models for flow simulation of the fuel rod bundle with a spacer assembly[J]. Applied Thermal Engineering, 2012, 40(7):389-396.
[15] Agbodemegbe V Y, Cheng X, Akaho E H K, et al. An investigation of the effect of split-type mixing vane on extent of crossflow between subchannels through the fuel rod gaps[J]. Annals of Nuclear Energy, 2016,88:174-185.
[16] 陶文铨. 数值传热学[M].2版. 西安:西安交通大学出版社, 2001.

压水堆燃料棒束新型定位格架的数值分析

Numerical analysis of a novel spacer grid in rod bundles of PWR

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 2

编辑推荐

Metrics

本文评价

访问统计

联系我们

[1]	宫亚芳, 曹玉会. 衬垫与箱壁间空隙对苹果预冷效果的影响[J]. 中国科学院大学学报, 2021, 38(2): 198-206.
[2]	李磊, 胡非, 程雪玲, 韩浩玉. Fluent在城市街区大气环境中的一个应用[J]. 中国科学院大学学报, 2004, 21(4): 476-480.