Journal of University of Chinese Academy of Sciences >
A clock calibration method for EPC Gen2 RFID tag
Received date: 2008-12-26
Revised date: 2009-05-19
Online published: 2009-11-15
A clock calibration method for RFID tag is proposed, including an EPC Gen2 compatible clock calibration command, an on-tag current switch network,and a reader-tag successive approximation calibration process. The results show that the method calibrates 50% fabrication error to 0.4% with 8-bit calibration registers.
LUO Qia-Si , GUO Li , ZHOU Yun-Chao , ZHANG Gang , LI Qing . A clock calibration method for EPC Gen2 RFID tag[J]. Journal of University of Chinese Academy of Sciences, 2009 , 26(6) : 846 -849 . DOI: 10.7523/j.issn.2095-6134.2009.6.017
[1] EPCglobal.Class-1 generation-2 UHF RFID protocol for communication at 860~960MHz version 1.2.0
[M]. 2008.
[2] ISO.Information technology—radio frequency identification for item management—Part 6: parameters for air interface communications at 860~960MHz
[S].2008.
[3] Impinj Inc.Gen 2 tag clock rate-what you need to know
[M].2005.
[4] Cilek F, Seemann K, Brenk D, et al.Ultra low power oscillator for UHF RFID transponder //Frequency Control Symposium, 2008 IEEE International. 2008:418-421.
[5] Barnett R,Jin L.A 0.8V 1.52MHz MSVC relaxation oscillator with inverted mirror feedback reference for UHF RFID //Conference 2006, IEEE Custom Integrated Circuits. 2006:769-772.
[6] Song F, Yin J, Liao H L, et al. Ultra-low-power clock generation circuit for EPC standard UHF RFID transponders
[J].Electronics Letters,2008,44:199-201.
[7] Enz C C,Vittoz E A.CMOS low-power analog circuit design //Designing Low Power Digital Systems,Emerging Technologies(1996).1996:79-133.
/
| 〈 |
|
〉 |