Journal of University of Chinese Academy of Sciences >
CPFD simulation of gas-solids flow in annular combustion chamber of large-scale circulating fluidized bed
Received date: 2015-03-13
Revised date: 2015-07-07
Online published: 2016-03-15
Annular combustion chamber was designed for large-scale circulating fluidized bed(CFB) to improve the secondary air penetration and increase the enclosing heat transfer surface. In this study, the gas-solids flow in a large-scale CFB with annular combustion chamber is investigated based on CPFD simulation. The results show that the pressure distribution and solids flux predicted by the numerical simulation are in good agreement with experimental results. The gas-solids flow behavior and non-uniformity characteristics of gas and solids mass fluxes at combustion chamber outlets are analyzed. The results can be used as valuable information for the optimum design of annular combustion chamber.
QIU Guizhi , YE Jiamin , WANG Haigang , WANG Xiaofang , WANG Fajun , SUN Yunkai , NIE Li . CPFD simulation of gas-solids flow in annular combustion chamber of large-scale circulating fluidized bed[J]. Journal of University of Chinese Academy of Sciences, 2016 , 33(2) : 218 -222 . DOI: 10.7523/j.issn.2095-6134.2016.02.011
[1] 吕俊复, 于龙, 张彦军, 等. 600MW超临界循环流化床锅炉[J]. 动力工程, 2007, 27(4):497-501.
[2] 吕清刚, 宋国良, 孙运凯, 等. 690t/h循环流化床锅炉设计特点与运行特性分析[J].动力工程学报, 2010, 30(12):899-903.
[3] 程乐鸣, 周星龙, 郑成航, 等. 大型循环流化床锅炉的发展[J]. 动力工程, 2008, 28(6):817-826.
[4] Hack H, Hotta A, Kettunen A, et al. Ultra-supercritical CFB technology to meet the challenge of climate change[R]. Foster Wheeler Energia Oy, Finland, 2008.
[5] 廖磊, 那永杰, 吕清刚, 等. 六个旋风分离器并联布置循环流化床的实验研究[J]. 中国电机工程学报, 2011, 31(11):11-16.
[6] 周星龙, 程乐鸣, 张俊春, 等. 六回路循环流化床颗粒浓度及循环流率实验研究[J]. 中国电机工程学报, 2012, 32(5): 9-14.
[7] 刘静, 王勤辉, 骆仲泱, 等. 600MWe超临界循环流化床锅炉的设计研究[J]. 动力工程, 2003, 23(1):2 179-2 184.
[8] 孙献斌. 超临界循环流化床锅炉的研发[J]. 热力发电, 2008, 37(1): 1-3.
[9] 聂立, 王鹏, 彭雷, 等. 600 MW超临界循环流化床锅炉的设计[J]. 动力工程, 2008, 28(5):701-706.
[10] 孙纪宁, 王哲, 杨志伟, 等. 裤衩腿循环流化床流动特性及翻床机理的研究[J]. 动力工程学报, 2010, 30(5):336-341.
[11] 李金晶, 李燕, 刘树清, 等. 裤衩腿结构循环流化床锅炉床料不平衡现象的数值模拟[J]. 动力工程, 2008, 28(1):28-32.
[12] 吕清刚, 高鸣, 孙运凯, 等. 大型循环流化床锅炉[P]. 北京:CN102226518A,2011-10-26.
[13] Andrews M J, Orourke P J. The multiphase particle-in-cell (MP-PIC) method for dense particulate flows[J]. International Journal of Multiphase Flow, 1996, 22(2): 379-402.
[14] Snider D M. An incompressible three-dimensional multiphase particle-in-cell model for dense particle flows[J]. Journal of Computational Physics, 2001, 170(2): 523-549.
[15] 王超. 600 MW超临界CFB锅炉炉膛气固流动特性的数值模拟研究[D]. 杭州:浙江大学,2011.
/
| 〈 |
|
〉 |